DUKKABOARD Tile Backer Board PanelsThere are 26 products.

DUKKABOARD Tile Backer Board Panels are made from extruded rigid polystyrene covered both sides with a glass fibre reinforcing mesh and coated with a synthetic mortar. Dukkaboards can be used in situations where Wedi or Marmox boards are specified, as they have similar properties and are easy to cut using a Stanley knife and straight-edge.These boards are impervious to moisture and rot proof. They also have very high thermal insulation properties and are ideal for use with under floor heating systems. The boards can be screwed to walls or floors using the countersunk washers shown below or bonded to solid walls using metal dowels and flexible adhesive.The Dukkaboards are screwed at 30cm centres with 9 fixings per sq. metre.The joints between the Dukkaboards should be covered with the joint reinforcement tape for extra strength.  PLEASE NOTE that any joints between boards or fixing holes drilled through them need to be sealed with either waterproof tape or the Mira tanking products listed on the waterproofing and tanking page if the Dukkaboards are being used in a wetroom or shower. The boards come in 1.3 metre or 2.6 metre lengths and are 600mm wide. The DUKKABOARD CREATIVE pre-scored panels are used to create curved walls, partitions and columns that are ready for tiling. The Mira waterproofing products are used to seal any joints and fixing holes in the Dukkaboards and Dukkaboard shower trays.
Please phone 07872 605 167 for further details

Cart  

No products

Shipping £0.00
Total £0.00

Check out

PayPal